The bevel cutting head allows you to cut beveled pieces. The height sensor comes with the bevel head but cannot be combined with the collision sensor.
The sensor in the abrasive feeder monitors the abrasive feed status.
Depending on the size and number of the cutting heads, 18-120 kg/h of abrasive sand is coming into the cutting table tank. The used abrasive and cutting waste is removed from the tank with pneumatic diaphragm pump, which circulates the water through the system.
Multiple zero-point setting for automatic cutting job que. Several sheets can be put on table and set individual zero points and cutting programs for each sheet (max 9 pcs). This option requires height sensor.
Unit is connected to the controller and it sends a SMS message to preset mobile phone number, when the program ends, or there is a fault with high pressure pump or cutting table. Customer is responsible for ordering a SIM-card. We recommend the mobile unit, if the system will be used for unmanned cutting.
The machine is available for manufacturer's remote diagnostics. This can be used for remote support and machine parameter adjustment.
Stainless steel lamellas are recommended for cutting of aluminum and stainless steel.
The used cutting water and fine cutting waste are pumped from the bottom of the basin by a submersible pump into the sedimentation basin. From there the water runs through the barriers to the drain.
Guns make it easy to clean the plate and parts after cutting.
